Clean power delivered precisely. Whether you need a 4-channel for your front stage or a dedicated mono block for your subwoofer, our amplifier selection covers every build tier — from Starter to Ultimate.
Class A/B amps run warm but deliver the cleanest sound — preferred for speaker channels. Class D amps are highly efficient (90%+) with minimal heat — ideal for subwoofer mono blocks. We match topology to application for every build.
Gain is the most misunderstood control on any amplifier. We set gain using a digital oscilloscope at the amplifier's output, not by ear. This ensures you get maximum clean output without clipping — protecting both your amp and your speakers.
Every amplifier installation uses correctly gauged OFC power cable run directly from the battery. Ground connections are made to chassis metal with a sanded, treated contact point — not sheet metal screws. Poor grounds destroy amplifiers.
RCA routing is separated from power cables wherever possible to prevent alternator whine and interference. We use twisted-pair shielded RCA cables and properly terminate all cable shields at a single ground point.
Amplifiers are mounted in locations with sufficient airflow — never under carpet or in sealed compartments. For installations in tight spaces, we add ventilation channels or low-noise fans to keep temperatures within spec.
A single-amplifier install (1 amp + sub) takes 4–6 hours. A 2-amplifier setup with full wiring takes 6–8 hours. Builds with a DSP processor, multiple amplifiers, and custom wiring management can take 1–2 full days.
Amplifier matching is critical. Let our team spec your power solution so every component performs at its absolute best.
Book a Consultation Use the Configurator